Quick and easy to install

- carpet knife

- pen and ruler

- straight batten or metal straightedge

- square

- thick mounting or structural adhesive (depending on installation base and adhesive, approx. 80-300 ml/sq m required)

 

Bring panels into the area where they will be installed at least 24 hours prior to installation. Plan locations of panels on wall, taking cut-outs for windows and doors into account.

 

Use a sharp carpet knife, cutting from the surfaced side.

 

Make a uniform bead of adhesive along the long sides and dot around the middle of the sheet.

Tongue-and-grooved wall panels can also be fastened with staples. Ensure a good fixing by gluing the middle of the panel.

 

Battens (supporting laths)

The battens must be at least 7 cm wide, with spacing of half of the width of the panel on centre (29/30 cm). The installation of panels is normally made on the old wall surfaces. In case the old surface is very uneven supporting laths are recommended.

 

Extension rings can be used to bring electrical sockets level with the wall surface. Corners and edges can be finished with suitable wood or plastic strips.

 

Individual installation instructions are included in the package, or you can download the Installation Instructions for Wall Panels leaflet in PDF format.

Advice and additional instructions are available from the manufacturer.